Install: Choose where you’d like to install your Contact Sensor and magnet.Main Doors have entry and exit delays to help prevent false alarms. Door and Window Settings: If you’re using the Contact Sensor on a door, remember to choose Main Door or Secondary Door.Configure: In the Ring app, choose the Sensor placement (Main Door, Secondary Door, or Window), give it a unique name describing the location, and assign it to a room.Connect: When the app prompts you, pull out the battery tab to power it on.Then go to Settings, then Monitoring to configure Assisted Monitoring. When you’re done, open the app and tap on the Menu.After you add your Base Station, open a web browser, visit /protect-plans and subscribe to the Ring Protect Plus plan.If your internet goes down, or your router loses power, cellular backup will send your Ring Alarm signal to the monitoring service.Ĭlick here to find out more about Assisted Monitoring. Your Ring Protect Plus subscription gives you other benefits including 24/7 cellular backup. Your Ring Alarm kit comes with a trial of Protect Plus. See a pattern not shown here? Visit /alarm-faq for more information.Īssisted Monitoring automatically calls your emergency contacts whenever your Ring Alarm detects a security issue and sounds the alarm.Ī subscription to Ring Protect Plus is needed before you can sign up for Assisted Monitoring (plus cellular backup). Once your Base Station is set up, you can tell its status by the colour and pattern shown on its light ring. When prompted, press the PAIRING button on the rear of your Base Station, as shown below. Once the ring is solid blue, the update is complete. TIP - The first time your Base Station connects to the internet, it will automatically begin a software update, which may take a few minutes.During the update, the light ring on your Base Station glows blue with a spinning yellow indicator. Follow the in-app instructions to complete setup.Now you’re ready to set up your Alarm Base Station in the Ring app. You should customise your Ring Alarm setup to meet your own needs.īefore you begin, make sure Bluetooth is enabled on your mobile device. This sample house shows how Ring Alarm can be set up in a home. Ring Outdoor Siren*: Alert passers by and deter unwelcome guests with Ring Alarm Outdoor Siren. Ring Range Extender: Extends the Z-Wave wireless network to reach distant Alarm devices. Mounts using the double sided tape on the back. Ring Motion Detector: Alerts you to movement inside your home. If the magnet is too large, open the back and remove the magnet piece from the magnet case and mount it directly. ![]() Ring Contact Sensor: Alerts you when a door or window is opened. ![]() Runs for months on battery, or connects to power using the USB cable and power supply. Mount it on a wall or place it on a table near a door you use often. ![]() Ring Keypad: Gives you hands-on control of Ring Alarm. Connects to power with the included power supply. It connects all of your Alarm devices to the Ring app, so you can stay in control of your home from anywhere. Ring Alarm Base Station: The central hub of your Ring Alarm system. For safety and compliance information for this product, click here.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |